I was trying to find a listing for what the proper torque setting is for the spark plugs on a '76 2.0 and cannot find one. I found two of the plugs loose when I went to replace them and I do not want that to happen again. I also don't want to over torque the plugs since it is an alloy head. Does anyone have the proper setting?
18 ft/lbs for a 911 head.....but a t-4s may be made of a diferent grade of beer can.
Nope, don't really know... but I twist them in by hand, then I barely give it a lil jiggle, til they are tight enough to require about 2 times that same amount to get them out again.
Just a sunggy..
M
as much as you can get when choking up on the ratchet with one hand. When that tendon in your wrist pops out thats tight enough.
Get a 1/2" breaker bar. Tighten until it strips, then back it out a quarter turn.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)