I'm redoing all of the fuel lines with this project. I bought steel brake lines from NAPA for about $4 a piece following pelican's article. I might end up bending the lines with a tube bender instead of using a 90deg fitting.
These are the sizes i've gathered so far:
Supply: 3/8"
Return: 5/16"
Fuel Rail: 5/16"
Fuel pressure regulator: 5/16"
Fuel filter: 3/8"
I'd like to put an inline fuel pressure gauge near the fuel rail using this stuff:
http://store.summitracing.com/partdetail.asp?part=ATM%2D2179
http://store.summitracing.com/partdetail.asp?autofilter=1&part=MRG%2D2975&N=115&autoview=sku
How did you guys put the 3/8" inline on the fuel rail side? With a 5/16" -> 3/8" adapter? Or did you end up placing the inline gauge on the 3/8" side next to the fuel filter?
my gauge is inside the engine compartment (fuel pump and filter up front)...used a "t" similar to that fitting and plumbed in before the pressure regulator........
QUOTE (Mueller @ Feb 7 2006, 03:55 PM) |
my gauge is inside the engine compartment (fuel pump and filter up front)...used a "t" similar to that fitting and plumbed in before the pressure regulator........ |
QUOTE (yarin @ Feb 7 2006, 04:59 PM) | ||
A 3/8 tee or 5/16 tee? |
Any idea where I can get that adapter in 8mm / 5/16" ?
It doesn't seem to exist anywhere.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)