Hey All. Anyone have a line on a block off plate for a type IV bus motor to bag the lower oil filler neck attachment? Thanks for any assistance. Regards, -K-
should just be a plate and a gasket right?
sounds like something pretty easy to make, if not commercially available.
I have a length of 1/8 inch stock that I could cut a cover plate/block off from, but I just figured if there was someone currently manufacturing a spiffy little piece that all I had to do was lather it up with some gasket material and "Gorrila-snot" that would be pretty smooth.
I made one out of 1/8" aluminum and I have one someone else made out of 1/4" steel plate.
Not a big deal.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)