I started building a center console so I can install a bass speaker in my car. When making the cardboard templates I found that it will run into the gas pedal. ...That can't be good.
Can anyone post a pic of the drivers side of a console, so I can see how this is dealt with?
On the drivers side the console side angles in away from the gas peddle,they hold it in that position with a small wood block at the fire wall end . Maybe someone has a pic. , my 914 is in storage or I'd send you one. Dave
i installed a factory console and then removed it because my right foot rubbed on the console. only size 9 shoes. if/since you're building a console, you could construct that side to allow for clearance for your lead foot.
here ya go.
k
Attached image(s)
QUOTE (rhodyguy @ Feb 17 2006, 05:54 AM) |
here ya go. k |
Thanks for the photo.....Comfy looking sox yu got there guy.
Had the same foot rub problem so I took the little wood block out at the back and screwed the sides together. No more rubbing.
QUOTE (MW 914 @ Feb 17 2006, 06:58 AM) | ||
...and you can see in the pic, his foot isn't even close to rubbing the console! ![]() |
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)