Looking for ideas from my homies. =-)
This is to take care of my two priorities.
1. Better ducted cooling for the rad AND brakes. (V8 and new 911 vented rotors)
2. and it must look maaaahvelous dahhhling.
AIR group 5 kit...
solves your "lack of tire" clearance immensly...
goes up tto 13's in the rear iirc...
americaninternationalracing.com
916
IMSA
QUOTE (Aaron Cox @ Feb 26 2006, 11:43 PM) |
AIR group 5 kit... solves your "lack of tire" clearance immensly... goes up tto 13's in the rear iirc... americaninternationalracing.com |
QUOTE (Mueller @ Feb 26 2006, 11:45 PM) |
916 IMSA |
maybe just remove the boobies from the front bumper and install this.
From Shure. FG.
I like that Renegade front bumper.
It's actually made by http://www.fiberwerks.com/prod01.htm... who also does some other cool stuff!
Hmmm,, Peel's front setup does look good.
on another car...
I want that setup...
but I might just make it myself....
Im learnin to use f/g
(btw, rogger, check out the rpm thread..)
QUOTE (Andyrew @ Feb 27 2006, 02:01 AM) |
I want that setup... but I might just make it myself.... Im learnin to use f/g (btw, rogger, check out the rpm thread..) |
QUOTE (Rand @ Feb 27 2006, 12:32 AM) |
I like that Renegade front bumper. It's actually made by http://www.fiberwerks.com/prod01.htm... who also does some other cool stuff! |
ok,
so far i'm thinking the renegade spoiler... and removing the boobies on my stock bumper, then buying the new rubber part that goes on the top.
(what is that called???)
then somehow using the fog light holes for brake cooling ducts..
QUOTE (Dr. Roger @ Feb 27 2006, 10:06 AM) |
ok, so far i'm thinking the renegade spoiler... and removing the boobies on my stock bumper, then buying the new rubber part that goes on the top. (what is that called???) then somehow using the fog light holes for brake cooling ducts.. |
QUOTE (Dr. Roger @ Feb 27 2006, 10:06 AM) |
so far i'm thinking the renegade spoiler... |
A guy comes on here looking for bumpers, and gets replies for body kits.. NICE
The bumpre on peal looked bitchen after the slant nose job... it didn't do it for me before, tweaked the lines a bit to much. kinda like the late model condom bumpers
The gold car pictured has a Fiberglass front bumper, and renegades air dam.
I vote for lose the tits, fill the holes, cut a new hole, re-chrome, and add an air dam. The bumper top is available, and someone was kicking aroung making them out of fiberglass.
BJH
QUOTE (Crazyhippy @ Feb 27 2006, 01:05 PM) |
A guy comes on here looking for bumpers, and gets replies for body kits.. NICE |
QUOTE (SirAndy @ Feb 27 2006, 12:50 PM) | ||
get the sheridan narrow or widebody kit ... the best body kit for the 914, IMHO ... http://www.ultimate914.com/MOTORSPORTS_WE/Sheridan_Motox.html |
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)