I`ve been lurking here for soom time now. About time I say THANKS! for all the tech advice, ideas, etc. Here is a picture of the final results. Barry
Attached image(s)
Wow, nice looking car, Barry!
I think you need to read the posts on adjusting the ride height. Whew, you are sitting waay up there! Lower that puppy down some.
Geoff
I dunno, rear looks too high to have an engine in it. Otherwise, NICE!
I like it.
Real clean.
Paul
I'm sure the rearend will come down when he adds the running gear.
CCLINRIDEHEIGHTADJUSTMENT
Other than the fact that she looks like she's about to go four-wheeling...
BEAUTIFUL JOB!!!
looks like stock beetle height... too high for the car, or like my parts car, no weight on it... but the body sure is PURRRRTY! real nice job!
Very nice. Red is one of those colors that looks "cluttered" with the sail panel vinyl installed... good job!
-Rusty
Has anyone noticed that the ass end is kinda high?
Yes the rear is to high. picture taken before engine and trans installed. Sorry just trying to rush it. Did you notice the side marker lights? `68 roadrunner! for that custom look!
Aw man, I thought it was a rally setup!
"cause I can"
Why is it sitting so high in the rear ??
I cannot BELIEVE OUR club members would ask that kind of question ??
I'm ashamed. And here I thought we where doing so well..
B
Hope to have this installed soon. 2 L W/96 mm forged pistons,H.D. valve springs,Mild cam(F.I.) H.D. oil pump,everything has been balanced,and the fly wheel lightened by 6# Hope it works ? It did run on the test stand w/ carbs.
Attached image(s)
Nice car, even the engine looks pretty.
I did see a picture of a 914 put onto a tracker type frame for a 4x4 once.
It actually looked better than the Cayanne.
I thought you were going for that 4x4 look we might see up here in Northern Ontario in the winter (October to May)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)