I have been having trouble locating a step stud of the proper lenght (stock). The PO for some reason drilled and tapped one of the studs to a 10 x 1.5 and used a 10 x 1.5 stud but it was near impossible to remove the heat exchange without cutting the nut.
Any way, does anyone know of a source for a step stud 10 x 1.5 to 8 x 1.25 at least 38 mm long from shoulder to tip? It would save me removing the head to get the hole filled and re-tapped.
Thanks,
Dan
Len Hoffman
http://www.haminc.biz/main.shtml
In a pinch you could use Type I rocker arms studs.
You'd have to shorten the 10mm side's length, but it's easily
doable.......
Don
I hooked him up.. These studs are a hot seller for us, no one else has them..
I'm all hooked up cannot wait to get it and finish my exhaust backdate project. Will post pics when done.
COOL!
I was thinking of getting at least 4 to have in the tool box.
Never know when someone is gonna need one!
Almost called Becca to have her add it to my order, but she scares me....
Don
QUOTE (dstar @ Mar 28 2006, 09:20 AM) |
In a pinch you could use Type I rocker arms studs. You'd have to shorten the 10mm side's length, but it's easily doable....... Don |
Anyone know the part #s for these step studs, T4store isn't loading right on my computer and I'm going to need some pretty soon.
I had to contact Jake directly they are not on the web site.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)