Hi guys,
Do any of you living up this way know of a local source of CV joint gaskets?
I know about Pelican and GPR , but was wondersing if we have a close source.
Thanks,
Tom
I just make them. NAPA has thick paper gasket material. Package store has beer. Proper application of both turns out nice new CV gaskets.
When you are in a pinch for thinner gaskets.... you only need the package store.... I was working on a dirt bike with a friend... went a way for a few hours and when I came back he had cut some gaskets out of thin carton cardboard.... in that case I think it was blue Pepsi gaskets.
tom, i think there's a vw shop/parts house on the water side just before you get to bremerton on hwy16. for basic maint stuff, small car performance in tacoma will get stuff for you in a day if they don't have it in stock. i shop there as does dave hunt.
k
Thanks for the replys guys.
Joe , I've made gaskets before back in my Navy days , so I think I will give it a try. Don't have much to lose. Just didn't know this would work for this application. By the way , I drilled out my bolts to 0.040 inches to allow some 0.032 inch lock wire. We'll see how that works.
Thanks again for the info.
Tom
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)