After having this on my list for over a year, I finally got around to it. For the last few months, since I put the new engine in, about every 10-20 miles I have been having to clean the idle jets.
When I pulled the fuel lines off, there was a lot of black gooey crud around the fuel drain fittings and a small amount of fine rust "silt". There were no big chunks of rust, but there was a fine coat of rust all over the inside walls.
I had a radiator shop boil it and I then treated it with the Por-15 metal prep and tank sealer. We sprayed the exterior with their black chassis paint... looks like NOS. This was a very easy project.
I am amazed at the difference. It is so pronounced, I feel like it is more of an "upgrade" than a "repair".
The motor is totally smooth from idle, to light acceleration thru out it's rpm's. Sustained revs in the lower range do not miss a beat. After a 100 miles the idle circuit is still totally smooth. I wish I had done this a year ago.
So if you've been thinking about it...
..
I agree completely. I just dealt with THE WORST EVER! There was about 2" of rust in the bottom of the tank. I'm surprised it still held gas.
I'll never tweak/tinker with another car that hasn't had it's gas tank cleaned.
Can you just clean the tank? I think im going to do this... My tank hasnt been done, but I havent seen any rust or anything, and I cleaned it out a while ago...
Might be time to do it right...
You can get a really good look at the inside of your tank by removing the expansion chamber AND the fuel gage sender (easy to do, about a dozen small bolts).
This way you have about a 2" and 3" hole, one of which you can shine a flashlight in while viewing thru the other opening. Allows you to really see a lot.
..
Cool; gonna do it thanks!
I had the same problem. The idle jets never stayed clean for more than a couple of weeks.
When the tank was pulled, about 200ml of sand (????) was in the bottom of the tank. I'm guessing the car was sandblasted at one time ... with the gas cap off!
This is what the return fuel line looked like ...
I turned the tank upside down and rinsed it out with a gardenhose!
Eddie
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)