What vendor has the best price for the rebuild kits for Weber 40 triple throat IDA's? My Webers have been sitting on the shelf for 2 years and I should clean them up before I stick them on The Beast.
Also, what's the best solution to clean them up with?
Thanks,
Bill P.
Bill, I may be the best vendor.. I think I have a set of rebuild kits leftover from when I converted to EFI..Ill run out to the trailer and check
if tim is of no help...
try PMO, or piercemanifolds.
Got mine from PMO
Thanks for the quick response guys. If TimT has them I'll go with him first (gotta support the Club members!). If not, I'll look at PMO or try some of the local shops to see if anyone has them in stock.
Bill P.
I'd if Tim doesn't have them, I'd go PMO, some of the kits out there have poorly made parts, like acc. pump diaphragms that are not particularly fuel resistant.
OK , I checked my trailer, I dont have two kits per se, but I do have enough gaskets, etc to rebuild a bunch of Webers. I only found one accel pump diaphragm though.
If you need two unadulterated kits try PMO, or Greenfield Foreign Auto in Mass. Though PMO is probably more convenient to you
does anyone have tuning info for tripple throat IDFs? my tail dragger is running RICH. where to position the bypass screws?
Generally, start with the by-pass screws fully closed, measure airflow, adjust screws so all barrels flow the same amount of air, then move on to the mixture screw
More info is needed... more than its "running rich"
Maybe running triple throat IDAs? Nice review of basic tuing in http://forums.pelicanparts.com/showthread.php?s=&threadid=67957 on the Pelican Board.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)