OK Maybe someone has run into this.
I was installing my tail lights yesterday. Had to figure out the wiring. As usual the Haynes manual was pratically worthless.
Think I have it all figured out.. at least everything is working as it should on the outside.
Here's the problem. When I turn my turn signals on the seat belt warning light flashes along with it, both directions.
But, here's more wierdness, the turn indicator on the tach will work correctly if I turn the drivers side TS on. If I turn the pass side TS on the indicator in the tach flashes as if I have the hazard switch on (you know both arrows).
Note: everthing is working outside the car just fine. Just not inside.
Also... where is that F&#$(&ing seat belt buzzer so I can disconnect the damn thing. Really F'in annoying.
EDIT - Oh and I just noticed that the hazard switch is not working.
for the post holiday crowd.
Any ideas people...
seat belt buzzer fix....
http://www.914world.com/bbs2/index.php?showtopic=46982&hl=warning+buzzer
I have the same problem with the turn signal on the tach. driver side works as it should but when passenegr side is turn both flash on the tach. My problem is the front turn signal housing. The bulb doesn't fit tight in the socket and I have to bend the socket to get the bulb tight. Yes it is the correct bulb, just a feature of my car
Check and make sure the bulbs are tight in the socket.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)