Took alot of coaxing but I gottr done. hole saw top of piston ,then torch top of rod off,ugly.
Sancast :wub:case ,crank,cams,fan,flywheel, etc. all good.
Note; this for fun I knew what I was buying.
Attached image(s)
It'll buff out...
Use that pic as an avatar......it's certainly offensive.
I had a 2.4 that was exactly like that. MFI was good though
Sandcast on a car with vented rear rotors?
That's one of those 'hunts while idleing' engines isn't *it?
Hey, it looks a good as the car it was in. No, it wasn't a "storm surge special" from the SE.
No slipping in a set of rings on that little guy.
Now that is how you take apart a motor!!! witha torch!!! WooHoo, I bet those pistons can't be used now....
Naw....bead blast them....they'll look like NOS.
You may have to do a bit of welding on the rods though.
Looks like alot of parts MotorMeister could use.....
picture on right look like chili cookoff
mongo like chili
mongo
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)