tried a few stores... 30mm DEEP for taking off tranny bolt....
as seen here
http://home.san.rr.com/pb914/rebuild/
trying to pull my gearstack so i can have it looked at. got almost all the way there...
AA
I have one
If you live next to autozone, check the one on the loan-a-tool list (website)
I don't know if that is deep enough for you...
AA
You'd be welcome to mine if I didn't need it on Sunday.
I found mine with the impact tools stuff, but I forget where i got it.
Maybe give Sears a call? Specify Impact sockets and maybe you could get lucky?
Also, please report on what what dicked up your trans. I'm sure you had everything turning before you put it back together, so I'm extra curious as to what effed it up after that.
Yup, I got one
Of course you one is here. What time you showing up with the tranny.
:PERMAGRIN: Joe
You're quite welcome to use mine. I can bring it over, with the breaker bar attatched, if it's not too far. I'm in Sherman Oaks.
Joe, i gotta pull the stack before i bring it over......
Call around, they are fairly easy to get.
Vice grips?
Call Slits
I have two 15mm.
got one...
you call and ask, do you have a 30mm deep socket? they say no.
you call and ask for a 30mm axle socket... oh yeah, we have one....
idiots....
AA
wow, we're almost a thousand miles away and we but parts from the same parts guy....
ROTFLMAO
FYI,
a 1 3/16" SAE is within .1 of 1/16" in size of a 30mm. my local flaps had the metric for three times the cost of the SAE.... a tenth of a sixteenth of an inch works for me. =-)
Do I win the CSOB contest??? LOL
Aaron,
We were at the shop all morning. You should have called. Could have busted it apart in 2 minutes.
Aaron I have a deep impact socket 30mm that you can use
Bernie
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)