I'm thinking I saw a thread in the past but I can't find it now. While doing some cleanup on an inner CV joint the bearing cage and bearings came apart. What's the correct technique to reassemble? I can get it together but can't get it to pivot
correctly?
Thanks in advance,
Ron
The Haynes manual has a pretty good description on how to get them back together.
When I did mine it took me a couple of tries but it eventually went back together okay...
Thanks for the advice- I'll take a look at the Haynes manual.
Ron
http://www.914world.com/bbs2/index.php?showtopic=31536 you go...
Thanks for the help! It went together perfectly on the first try!
Have a good 4th!
Ron
If it worked first try, you might have not got it in correctly. A while back I remember I thought I had it first try but if the CV doesnt move up and down the shaft, then you dont have it fitted correctly.
ps. dont forget your MoS2 paste
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)