So it runs. Drove it tonight. I looked like this afterwards
But while finishing it up I found I was short one CV plate (plate is what Porsche calls them). Guess the guys that dropped the Schnorr washers also dropped the plate. NP I thought, I'll just use one off the parts car. I slide it on and start to hand tighten the bolts and it binds. WTF!! I pull it off and one of the original ones that I had just put on and compare.
The stock CV plate is on top of the one from the car in picture 1 and the two side by side in picture 2
So what size/type CV's do I have?
I'm guessing the output flanges are different than stock also, for the CV to bolt up to it?
The bolts are a couple mm longer than stock also. I tryed to use ones off the parts car and they wouldn't tighten down.
Attached image(s)
[quote name='GWN7' date='Jun 28 2006, 10:31 PM' post='715255']
So it runs. Drove it tonight. I looked like this afterwards
I "feel" your joy!
"The stock CV plate is on top of the one from the car in picture 1 and the two side by side in picture 2
So what size/type CV's do I have? "
The top pic is the very same as my "plates"
Maybe the other "plate" is VW? More knowledgeable than I will respond.
"The bolts are a couple mm longer than stock also. I tryed to use ones off the parts car and they wouldn't tighten down."
VW bus?
Dang! I'm lost as you are.
Glad to hear that it's a runnin'!
..
..
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)