Ok any tricks on installing the rubber seal for the engine tin ?? Pic would be greatThanks
Liquid soap if a flat tip screw driver and some patience doesnt work.....you arnt done yet!?
I say, choice words my friend, choice words. Talk to it and it will listen.
Make shure the kids ain't around first.
If you're talking about the ones along the engine shelf it's really not too hard. I have done a few and they seemed to go in without too much difficulty.
I used the widest bladed screw driver I could find and put a piece of duct tape on the end so I wouldn't tear it and just worked it into the channel.
Start with one side in the groove and start pushing the other into it. I also found it easier if you do it from the bottom...
ok I'll party with it sounds like a good time to be had ,Thanks again
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)