Printable Version of Topic

Posted by: bmunday Jul 6 2006, 07:56 AM

I went over and bought a voltage gauge the other day, not OEM, but a gauge just the same. The directions are for sheet, so I called just to verify installation. I was directed to wire it directlyto the battery and I should be good to go. Well I hooked it up to the factory gauge power source, so that the light wasn't on all the time. Well it ligts up, but when the car is running, I don't get a reading, the needle dosen't move. So either I have wired it wrong, (most likely), or it's defective..

Bueller..... Bueller....... Bueller.... ? Can anyone help me out?


Thanks
Brian

Posted by: TROJANMAN Jul 6 2006, 09:05 AM

check to make sure the bolts are not too long....
oh, and make sure you don;t lock it in the trunk either. it won't do you any good in there

Posted by: bmunday Jul 6 2006, 09:12 AM

I can always count on you for help....

Smart ass. Didn't your mother evertell you if you don't have someting nice to say, to just shut the F&@* up....

Posted by: BMartin914 Jul 6 2006, 09:38 AM

This is actually quite out of character for greg.

Ahhh, Brian, the search feature is a wonderful thing!

http://www.914world.com/bbs2/index.php?showtopic=15329&hl=volt+gauge+installation

Posted by: bmunday Jul 6 2006, 10:17 AM

Thanks Ben, I didn't see this list earlier, I did look, but didn't really see what I was looking for...... Out of character, it's just one of the many services, that he offers...

Posted by: BMartin914 Jul 6 2006, 12:02 PM

I don't know what services he has offered you...