Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Another dumb question?
Posted by: East coaster Jul 6 2006, 09:38 PM
I'm installing my rear window tomorrow and since I already completely cleaned all the tape/residue from the window, there's no longer any tell tale signs of which side was inside and which was out! The only way to distinguish one side from the other is the v-dub logo/text on one side.
Does the little V-dub logo go on the inside or out??
I realize it probably doesn't matter, but I'd rather put it back the way it supposed to be.
Posted by: Mike McGrath Jul 6 2006, 10:01 PM
I'm installing my rear window tomorrow and since I already completely cleaned all the tape/residue from the window, there's no longer any tell tale signs of which side was inside and which was out! The only way to distinguish one side from the other is the v-dub logo/text on one side.
Does the little V-dub logo go on the inside or out??
I realize it probably doesn't matter, but I'd rather put it back the way it supposed to be.
Someone once told me that it did matter and you were supposed to put it back in the same side in and out. Are you sure you cleaned it that well??? Maybe there's a little left. I'd try it both ways to make sure, just in case.
Mike (in Portland)
Posted by: So.Cal.914 Jul 6 2006, 10:09 PM
I haven't done much auto glass, but I have worked as a glazer. When we would
set glass we would put the bug on the inside at the bottem
Posted by: jonwatts Jul 6 2006, 11:12 PM
If you breath on the glass (fog it up) near the edge you may be able to tell which side had the seal and which didn't.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)