For some reason the brake indicator light just keeps flashing when the motor is running. I have the E brake all the way to the floor so the switch is being pushed in. I even pushed the switch with a screw driver to make sure it was being pushed in all the way. Still flashes. Another thing I noticed is the reservoir is pushing up brake fluid up past the cap and it is puddling around the cap. Any thoughts? Eddy
i'm having the same problem, except mine stopped flashing and just clicks now.
try pressing the reset button on the side of the master cylinder to shut off the light...if the reservoir is filled to the top it will over flow when the fluid gets hot and expands..
Once you have confirmed that all is well with the MC try looking for a break in the brown/yellow wire that feeds the brake light switch. Check for a pinch around the seat mounting hardware.
The brakes feel fine. I looked behind the brake pedal for the reset, but did not find it. Where is the reset? Eddy
I climbed under the car and found a brown wire that attaches to the switch had fallen off the terminal. Plugged it back in and all is well. I pushed the reset just in case??? All is well. Eddy
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)