Printable Version of Topic

Posted by: MJHanna Oct 13 2003, 11:36 AM

If your going to run carbs then run some air cleaners that will let them breath.


Attached image(s)

Posted by: URY914 Oct 13 2003, 11:39 AM

Is that a Mallory dizzy?

Paul

Posted by: MJHanna Oct 13 2003, 03:23 PM

Nope MSD , plugs into a 6AL with part of a 911 wire set for wires.


Attached image(s)

Posted by: Lotus914 Oct 13 2003, 08:47 PM

Those is BIG! No rain tray on that car!

Dave

Posted by: Aaron Cox Oct 13 2003, 08:55 PM

does anyone make watershields for /4's?

Posted by: mharrison Oct 13 2003, 09:26 PM

Is the front wall of the trunk cut so those air cleaners will fit, or cut for something else?

Posted by: MJHanna Oct 14 2003, 02:57 PM

Cut for easy access to adjust carbs , linkage not for the air cleaners. I dont worry about water with this car can you tell


Attached image(s)

Posted by: Brad Roberts Oct 15 2003, 01:25 AM

Oberg oil filter... cool.

Yep. I like the tall stacks with tall air cleaners.


Why the 911 wire set Mark ?? What have you found ??


B

Posted by: maf914 Oct 15 2003, 07:19 AM

What type hose and fittings are you using for your oil lines? They look like commercial type hydraulic lines with crimped fittings.

Thanks,

Mike

Posted by: rhodyguy Oct 15 2003, 07:20 AM

is that a hot start relay mounted in the trunk too?

kevin

Posted by: MJHanna Oct 15 2003, 07:45 AM

Paranoid is the reason for the Oberg tattle tail filter. I have run MSD wires for years as the MSD 6 AL really likes them and they plug into to the MSD dizzy but they suck at the plug end. You have to cut the rubber down and they give a poor seal. The 911 wires just happen to have the same connection as the MSD dizzy with better end for sealing and attachment to the spark plug. The MSD signal likes them.



The hose are all Aeroquip with the “press on” end fittings I have used them for years. You have to cut the ends off the hose if you want to get them off. This hose is the same hose that Aeroquip uses on the Steel braided hose, just less expensive and easier to get. Your right, you can go to any hydraulic house and get it.

Posted by: MJHanna Oct 15 2003, 07:46 AM

Yes, it got moved, to keep it out of the way and to "Clean it up".

Posted by: MJHanna Oct 15 2003, 07:49 AM

you can see the fittings a little better


Attached image(s)

Posted by: MJHanna Oct 15 2003, 07:51 AM

heres the hot start


Attached image(s)