I am trying to install some of my wiring harness back into my car. Haynes diagram for a 73 shows a brown & brown/white going to the master cylinder switch. I have both wires, but just one terminal on the switch. Pulled the master cylinder out of the 76 parts car, and just one terminal on it also. I am guessing that the brown/white wire goes on the switch. If so, where does the brown wire hook up, or is it "just there" ?? Been too long since I pulled it apart !!!!
Brown w/ white goes to the switch. Brown goes to ground on the body. With a single pole switch, it would appear that the ground is thru the switch on the MC and therefore, the brown wire is not needed.
OK ...that is what I was thinking. So .....I just need to ignore the brown wire....right ???
That would be my thinking.
Ok ...thanks Slits !!!!! One more headach out of the way in this clusterfuch of wires !!!!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)