i need a pix of the mounting bracket that mounts the ECU to the battery tray for D-jet. i have the bracket that bends over the end and has the hole for the idle mixture adjust knob, but that bracket has 2 holes for screws that mount into the bracket (that i'm looking for a pix of) that looks like it attaches to the battery tray. there are a couple of pix in the factory workshop manual and the PET, but nothing good enough to recognize the bracket or dimensions to fab a bracket. the old engine is carbed and the replacement is FI. thanks. and if you have pix of the mounting on the other end of the ECU, i could use that too. i have a small bracket that is curved and has 2 slots which i think is for the second mounting screw holes.
many TIA
Attached File(s)
ECU_bracket.jpg.doc ( 189k )
Number of downloads: 133
Is this what your lookin' 4???
Attached image(s)
that's probably it. thanks. i don't remember that in my parts stash.
more pix appreciated from anyone.
How 'bout this pic???
Attached image(s)
Each of the two pix shows half of the complete bracket set. Two parts with two bolts holding them together.
How's this then for showing how the bracket/ECU mounts to the battery tray.
Attached image(s)
excellent, thanks! i have the half that curves over the end of the ECU, but need the other piece. anyone have an extra?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)