When boring and honing 914 cylinders shoud you use a torque plate or not?
You must use one.
Mandatory....!!!!!!!!!!!!!!!!!!!!!!
Twystd1
Its a must, or you'll end up with a huge taper in the bore...
Blake, I can save you a LOT of trouble and guesswork!
I was 99% sure I had too. Jake I need to get some work done on the block. When is a good time to call you?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)