Right, so this drama has unfolded over the last 2 weeks that I have this weird shimmy in the front end. I asked for all kinds of advice and tips from you all and you all have responded, so thank you.
Anyway, I had rotated my tires front to back as one of the first things I did to isolate the problem. Still was there. Repacked the bearings. Still there. Tonight I was going to balance the tires and check the tie rods. I have newish (2 years) turbo tie rods, so I was pretty sure it wasn't there.
So I pull the front passenger wheel tonight and put it on the balancer. It starts to spin, and all of a sudden.... WTF was that?!?!?!? Theres a damn bubble in the tread, where the tread is lifting up. Delaminating as some have said. Pissed, I pull the spare, and mount it. I take the car for a ride and the shimmy is pretty much gone.
So my friend Tom is with me, asking all kinds of questions about the car (its on a lift and we are under it), and I show him the clutch cable, speedo cable, shift rod, etc... He spins the drivers side rear tire and WTF!!!!!! Remember how I rotated front to back and still had the shimmy? Well, I have two fuchin' tires with bubbles in them. Thats why the shimmy didn't go away when I rotated the tires.
These are newish (less than 7k miles) Bridgestones. I am so pissed. I need to call the shop where I got them tomorrow and see if there is anything that can be done, otherwise, its a letter writing campaign to bridgestone.
Anyone have any experience in this area? Please let me know.
Thanks,
Joe
Now go buy some Hankooks. and be done with it.
Glad you found it sorry about the tires. Bridgestones are made in Japan and Firestone in USA. Same corporation for what it's worth.
get some yoko's for the street
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)