Hi All
My front fresh air fan has never worked. I pulled it out when I had the gas tank out, and even with direct power, it's dead. So, I am goin to replace it this winter. When I pulled it last time, I had lots of trouble getting all of the push/pull cables hooked back up. Does anyone know the correct sequence for dissassembly/re assembly? I am going to go through the entire system, and I want it to operate correctly.
Any help is GREATLY appreciated!
Thanks -
Scott S
this is a job that requires a large amount of beer.
you see its a frustrating job, so you can use the beer to aid in frustration tolerance.
good luck
brant
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)