Hi All,
I've never done this job before and am planning on replacing the front and rear bearings on a stock 74. Does anybody have a link or a document with instructions or any advice on pitfalls to look out for? The Haynes manual has pretty detailed info for the front but nothing for the rear other than a diagram. Thanks in advance for your help
FB
Check out the tech articles on Pelicanparts. There is one on 5-lug rear conversion ... changing the bearing is the same. The trick with the threaded rod works nice.
One piece of advise ... get a big steel hammer to knock the hubs out.
Thanks, the Pelican article is exactly what I was looking for
This job looks to be a much larger pain in the a** than anticipated. Wish me luck
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)