I have weber 44IDF's on my 2.0 and I noticed the accelerator jets on one of them drip while the car idles. The car also gives a pop through the exhaust, almost a backfire but not quite. The valves are adjusted and the timing is set at 27 degrees, so I think the drips are causing my problems.
Are these drips a indicator of bad float adjustment? How do I stop them?
First check at the carb base on the shaft between the barrels where the cam that moves the pump arm lives. Spray some cleaner and wd-39 to see if there is crap hanging it up. What haps with my 40 idf is that the little metal wheel at the end of that arm gets all gommed up...
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)