Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ EGR block off

Posted by: CoolAirVw Nov 26 2006, 03:56 PM

I had very hard time finding the fittings to block off my EGR. Would there be any interest in a kit with 4 fittings and balls to do this? I would sell them basically at cost.

Here’s how I blocked them off. I could have just cut the fittings off my EGR tubes but I didn’t want to make them unusable for the future.

Attached Image

Here's what it looks like installed.

Attached Image




Posted by: Mueller Nov 26 2006, 08:12 PM

BTDT with the bearings...later on I removed the tubes and used a set screw....I wanna say it was 10mm .75 thread

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)