Was bored so I decided to recover my alternator wiring harness, cleaned up really well. Cleaned all the contacts, then recovered the harness.
Attached image(s)
Looks good. Nice Job!
One more showing a little more detail
Attached image(s)
what's your address so i can send you mine
nice job
Very cool! I used the same method (expando tubing and shrink tubing at the ends) for most of my conversion wiring. Really comes out looking good.
-Tony
I like it...
In fact, I'm trying to figure a way to recover my FI harness without removing all the connectors...Any thoughts on redoing yours...Ooops, if you have carbs, never mind...
2-OH!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)