I am refering to the small pulley that mounts to the block and is part of the thermostat / cooling flap arrangement.
I found one in my parts bin, but I don't think it is the right pulley. Anyone have a good picture?
thanks
hmmm, that doesn't look like the one I have. Mine is too thick for the bolt that goes with it.
I guess its time to get creative.
thanks for the picture!!!
Too thick....hmmmm
Is it a clutch cable pully instead?
Tommy-
You got the engine out of yer perty car?
Ok, here is a photo of the pulley I found in my parts bin and the bolt I pulled out of the motor. These obviously don't go together. But it could be that I don't have the correct bolt.
Can anyone confirm????
thanks
Attached image(s)
looks like right bolt but wrong pully - the pulley looks like the plastic hinge roller for the rear trunk - just my guess...
opps, I responded too soon. that bolt goes with that roller which goes on the rear trunk hinge.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)