Printable Version of Topic

Posted by: michel richard Dec 24 2006, 10:17 AM

Glenn was kind enough to send me these. It appears that all 4 are identical, but that the top ones are mounted upside down, i.e. the little chamfer should be on the opposite side for the lower and top plates.
I don't have exact information as to material and thickness.
Still, this should help.




Attached image(s)

Posted by: michel richard Dec 24 2006, 10:21 AM

Let's try this again.




Attached image(s)

Posted by: Aaron Cox Dec 24 2006, 10:22 AM

thanks very much michel and Glenn

Posted by: ChrisNPDrider Dec 24 2006, 12:47 PM

Nice! This little project is still pretty low on the To Do List, so iff'n anybody gets the gumption to tool up and do a run of these, I will gladly pitch in $$$ for 4.

Posted by: ClayPerrine Dec 24 2006, 12:51 PM

How about a little elaboration....

What are these for? I can't picture where they would go.

Posted by: Travis Neff Dec 24 2006, 01:03 PM

one piece headlight covers??

Posted by: Rotten Robby Dec 24 2006, 01:09 PM

Hood pin templates from the GT

Posted by: ClayPerrine Dec 24 2006, 01:11 PM

COOL!!!


I am going to have to take a look at maybe making a set for my car....

Posted by: michel richard Dec 24 2006, 04:30 PM

Here is a picture, from Armando Serrano's site:



Attached image(s)