I need a new rubber seal for the engine compartment to go on the tin. PP does not have one and has no suggestions.
Bernie
Are you talking about the seals on all four sides of the engine bay that seal up against the engine tin?
Seek out jbfrenz on e-bay. He has sets of all 4 for about $100.
yes those are the ones. doing a new 2.0 L motor and I need all the seals
Bernie
Voila! I was right!
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=46098&item=2443033757
www.pap-auto.com
Left and right are 7.68 each. The rear is 28.02. The rubber is just like the original.
http://www.pap-parts.com/store/prodinfo.asp?number=914%20504%20157%2010&variation=&aitem=2&mitem=21
http://www.pap-parts.com/store/prodinfo.asp?number=914%20504%20155%2010&variation=&aitem=3&mitem=21
Barry
Alright...those prices are to good to be true! How is the quality? They are not that foam crap are they?
Hmmm...Might have to update my Xmas list!
I orderded the left and rear seal they do not have right side?
I bought two left sides
Bernie
They are real. I was happy to see that the one I ordered (left side) was real rubber and still had the power on it. for 7.68, why not? Y'all have instired me to order the rest. I'll let y'all know. For $50 you can have the whole set!
Barry
WHen you say pre-bent, do you mean this... The picture sucks but you can see the idea. It has a hard rubber for the channel and bends around to clip on the tin at the bottom. I'm going to inquire tomorrow about the right. The company split into 2 seperate areas, used and new parts. I'm sure they have the right. The left will not work as the right since there is an angle that joins the left and right to the front tin seal. I would call them tomorrow and get the right. Anywhich way, $7.68, spare!
BB
Then no, its a solid piece with no bends..
BB
if i cant use it im only out $8.00 and I can use it next time
Bernie
That end view photo, showing the section that slides into the channel, looks a little different than what I remember what my existing ones looked like....BUT...... it looks close enough and the price is right.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)