Printable Version of Topic

Posted by: PRS914-6 Feb 11 2007, 06:51 PM

I have posted this before but finally took some pictures of the process. I never beat out races out my hubs because it always damages the "seat" where the races press against and it can cock the race as a result.

If you run a bead around the race and let it cool, it will shrink and you can push the race out by hand and never touch it with a tool. If it won't come, run another bead.

The picture with the pencil shows the lip that gets damaged when you beat them out with a drift and hammer.

To reinstall, I heat the hub with an oven or sometimes my torch with a large rose bud. I have the press set up with all the tools ready so they can be quickly installed.

Posted by: Twystd1 Feb 11 2007, 11:15 PM

That is also the easiest way to remove valve seats that I know of.

Cept I use a TIG.

C

Posted by: Andyrew Feb 12 2007, 12:13 AM

Nice mig bead! Just perfect enough penitration so as it is just topical enough to shrink the bearing when it cools!!

Nice..

Posted by: Mueller Feb 12 2007, 10:53 AM

or you heat the entire hub in an oven, the alum will expand much faster...

neat idea with the welder, never thought of it !!!!

Posted by: andys Feb 12 2007, 12:13 PM

Paul,

Any potential issues with changing the condition or even going past the critical temperature of the aluminum? That seems like an awful lot of heat to transfer into the hub area immediately aroung the race. Just a thought.

Andys

Posted by: morph Feb 12 2007, 09:59 PM

this is why i love this board i learn things i NEVER have thought of
james

Posted by: PRS914-6 Feb 12 2007, 11:30 PM

QUOTE(andys @ Feb 12 2007, 10:13 AM)