Printable Version of Topic

Posted by: TimT Feb 15 2007, 09:02 PM

We are nearly done with a cool little project.

3.4L, Haltech E6, twin turbos.

We fabricated the intercooler/exhaust

The customer wanted to retain heat etc




Attached thumbnail(s)

Posted by: TimT Feb 15 2007, 09:03 PM

muffler


Attached thumbnail(s)

Posted by: TimT Feb 15 2007, 09:03 PM

exhaust


Attached thumbnail(s)

Posted by: TimT Feb 15 2007, 09:05 PM

insulated


thats all for now

Posted by: Brando Feb 15 2007, 09:05 PM

How well do those exhaust manifolds flow?

Looks awesome. How long will it take you to transfer that over to the 914?

Posted by: TimT Feb 15 2007, 09:09 PM

those are some old B&B headers that we hacked up for this. I think they are
1-3/4" so they flow plenty.

We could stuff this in a 914 Im sure

Posted by: Brando Feb 15 2007, 09:12 PM

Wierd... with those 'heater boxes' on there, it looked like the exhaust manifolds were just welded up rectangles

I got a shoe-horn if you got the KY...

Posted by: tdsmoonchild Feb 17 2007, 08:13 AM

sweeeeeet!

Posted by: RSWannabe Feb 17 2007, 08:46 AM

Really impressive build. Just curious, what are you doing for the intake side of the turbos? Does not look like there is alot of room for filters. Also, do you have any concern about the waste gates venting ontot the turbos/into the intakes?

Brooke

Posted by: Mueller Feb 17 2007, 11:06 AM

very nice...I love the green on the motor and related parts !!!

Posted by: TimT Feb 17 2007, 12:06 PM

The air filters will sit on either side of the intercooler. There is enough room to run some hose back up into the engine compartment. The wastegates are actually below the turbo inlets, and are pointed down, so no worries about that



The customer wanted to be able to see all the powder coated bits, so the intercooler is mounted higher than we normally would mount one.

intercooler is a 12X24X3.5

trial fit to get ideas how to plumb things




Attached image(s)