Printable Version of Topic

Posted by: SteveSr Nov 25 2003, 11:58 AM

So now I'm looking at my V6 under my car bolted to the transaxle and I see that the intake will probably hit the bulkhead which is the front part of the rear trunk when I raise it up into the car. I was going to just cut some clearance,but now I want to cut the whole trunk out and cross brace....weld in some tubing before?????..at least between the shock towers???



Steve

Posted by: SirAndy Nov 25 2003, 12:20 PM

yupp. there was a thread about this about 2 weeks ago. search for it, it had a lot of good pictures ...

Andy

Posted by: Brad Roberts Nov 25 2003, 12:33 PM

Which V6 ?? Typically only the large HEI dizzy's hit the bulkhead and require a "notch".. not complete removal.

I know the 4.3 GM injected V6 with the small dizzy fits "ok".


B

Posted by: SteveSr Nov 25 2003, 02:29 PM

It's a 3.1 GM,I'm using the factory fuel injection.....ie (no distributor) from a front wheel drive car,now the intake points rearward.I'm thinking no room for the air cleaner boot and air box.....



Steve