the rear blower only goes on if i pull the console lever up as it is supposed to -but- i have to pull and hold it in the full up position, if it goes down a fraction the fan turns off. where is the switch and can it be adjusted?
i also just completed installing the misc. j and s-tube items to complete the heating system. does anyone know of a heat resistant tape or ? to seal for hot air pipe leaks?
The switch is on the lever itself. IF you take the lever out, you will see a set of contacts that moves, and grounds itself to the lever body. There is a nut you can tighten, and increase the tension on the lever, which should keep it up.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)