Printable Version of Topic

Posted by: brp914 Mar 11 2007, 08:32 PM

1. how many 0.090" thrust races are needed? seems to me you need 4 per A-arm. I have 4 total.

2. how do you seal the A-arms against dirt/water ingress?

Posted by: skline Mar 11 2007, 08:52 PM

If this is for your suspension, you need two per side and then you put the washer and O-ring on and seal it with silicone. Did you read the directions?

Posted by: db9146 Mar 11 2007, 08:56 PM

There are instructions? I purchased some remaining components from someone who used to make them and sell them on the board but I never got any instructions.

Posted by: Twystd1 Mar 11 2007, 09:05 PM

Scott... hows the new car doing????

Is Brando there yet???

C

Posted by: brp914 Mar 11 2007, 09:24 PM

the instructions say put on a washer, then a thrust bearing, then another washer (without saying whether this is the front or rear of the A-arm). ok, fine. but I have 4 thrust bearings and 4 thrust washers. So I have 2 too many bearings, or 4 too few washers. also, no orings.

Posted by: skline Mar 12 2007, 06:48 AM

I sent you a PM.

I have a PDF file with the instructions on how to put them in.

Posted by: skline Mar 12 2007, 06:50 AM

Whats up Clayton? The car is coming along as good as can be so far. Lots of work to do in all aspects. Brandon came and left in a blink. We were just getting ready to eat dinner so he didnt stay long.