My engine and transmission mounts have no rubber pieces, like I have read they should have. I'm going to get new mounts. I assume the rubber donut for the engine mount goes on top, above the mounting plate? I
The transmission mount is the same way, no rubber damper at all.
I'm thinking of using JWest hard nylon mounts for the engine and the solid mounts from PP for the transmission, anyone else use these?
Thanks
I was looking at the 911 sport mounts also. Are the aftermarket brands as good as the OEM?
if i read this correctly...for your 76', the engine mounts (039 199 231) are inboard on top (near the center) of the engine support bar. the front outside mounts are pieces of steel (914 375 181 00).
k
The engine bar is bolted without any rubber at the ends to the chassis. At the engine behind the fan is two rubber mounts. Those do go bad and are cheap.
On the tranny mounts, some like the 911 solid engine mounts (sport) or the 914/6 ones.
The 914/4 tranny mounts are not solid rubber and pretty soft so they fail the easiest.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)