Front trunk seal channel
Here's the left side
Attached image(s)
I hate when that happens!
The never ending battle if you live in the NW, Dave.
Geoff
The other day, when you said you were thankful to be done with the rust repair, I thought about emailing you because I didn't see any work you did on the trunk channels. Mine were rusted in the front, but not bad enough to cut out metal. I think I fiberglassed a small hole in the front. They say that it is best not to glue in a seal, rather leave it unglued that way you can clean the channels.
I'll get it. Here's after Metal Ready and Por 15
Attached image(s)
Here's the other side. Couple of small holes
Attached image(s)
I welded them up
Attached image(s)
Treated it with Metal Ready and Por 15
Attached image(s)
Man the first time I looked at the right channel I thought I could see right through like it was lace. I had a parts car that was all rusted through. Good to see your getting it.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)