Ok who makes an Alum pedal with a pivot on it to replace the orignal rubber and rust one?? I know somebody has done it before
saw it in a English 911 magazine. Hop to the Barnes and Noble and you should have no problem finding it.
Not to hard to make your own as well
Mine broke and needed to be fixed asap so I made one. Used a piece of aluminum riveted to a length of aluminum piano hinge (I think I TIG tack welded after that too). I cut the 'ball socket' area off the old one , trimmed off most of the plastic, and riveted it to the back. Can't weld that one since it has plastic in it and is also made of steel inside. Been thinking of adding a few decorative/grip rivets. Of course those are all aluminum too.
Looks very nice, should never break, and wont rust.
SMD
One like this?
They are only $250 at Pelican Parts.
I sold one for 10-15 on here a while ago. They SUCK OUT LOUD!!!!!
Attached image(s)
Or just buy the gas pedal for a 964.....bolts right in and it is all plastic, no metal hinge to rust. The accelerator ball pops right into the back.
They cost less then $10 brand new.
Damm Dan that sounds pretty cool and Light where do ya order one at
I broke the metal hinge on my pedal, so i just sawzalled off hinge area, so i was left with just the pedal.
Then i took a door hinge and cut out the hinge to fit inside the back channel of the pedal and redrilled the bottom part of the hinge to match the original holes on the floorboard. works great. let me know if u want pictures.
-Peter
The plastic 911 model (early?) that the bird board sells works great, but the mounting for the ball-cup is in the wrong place. You need to modify it so that the accellerator ball connects a bit lower on the back of the pedal. I won't tell you how I modifed mine, kinda embarrasing...
REAL men use Moon gas pedals ................. The Cap'n
If you have to ask, you're not a real man ..........
Same ones I bought through the group buy. They work great.
Instead of using the supplied cup which they eventually replaced with the better fitting one, I cut up my old rubber pedal and fastened its cup to the new pedal.
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)