they went on smooth as silk. just need to tighten them down. thanks ya'll .
k
Purely from memory - lets see if I am perma
17 lbs
Whatever the torque spec is, odds are it'll need to be tighter. I run 'em and do the final tightening while it's hot (and running). The Cap'n
On Tunacan they say 14#s. I set mine to this setting cold during build and will retorque to a slightly higher setting once the motor is warm and the cam is broken in...while the motor is still pretty warm...
i asked the same question a long time ago and Jake said 18 ft-lb
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)