Hello again,
I just purchaced to new engine mounts from PP but there smaller than the ones in the car now. Did I order the wrong ones ? I bought the 911 sport mounts and I need the engine bar mounts . Heres a pic.
Attached image(s)
i would think they would probably work.
but then again, i really dont know.
The top one is a original 914 trans mount. It was used for engine mounts on the 70-72 cars. The 911 sport mount will work fine. There is a little height difference. You might get a set for the trans also to get the same height all the way arround.
I have purchaced solid Trans. mounts since I have a tail shifter I'll take all the help I can get. But the front mount doesn't even fill the hole where the OE came out of thats what scares me . but the mounting holes line up.
jbart
Modern bonding techniques, better materials .... what more could you ask?
Install them correctly and they will work fine.
I gotcha My only worry is the gap look below for pics. But if you think it's good to go i'll beleave you cuz I no no better
Attached image(s)
Don't worry about the gap...
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)