Posted by: kconway Jul 9 2007, 07:35 PM
I suppose it could be either, but is the thread pitch for the M6 & M8 fasteners 1.0mm or 1.25mm? Is it mixed?
Kev
Posted by: John Jul 9 2007, 08:13 PM
QUOTE(kconway @ Jul 9 2007, 05:35 PM)
I suppose it could be either, but is the thread pitch for the M6 & M8 fasteners 1.0mm or 1.25mm? Is it mixed?
Kev
On a Porsche, typically they are M6x1.0 and M8x1.25.
Posted by: ptravnic Jul 9 2007, 08:49 PM
QUOTE(John @ Jul 9 2007, 10:13 PM)
QUOTE(kconway @ Jul 9 2007, 05:35 PM)
I suppose it could be either, but is the thread pitch for the M6 & M8 fasteners 1.0mm or 1.25mm? Is it mixed?
Kev
On a Porsche, typically they are M6x1.0 and M8x1.25.
There are a few exceptions on our lil teeners. If you don't have a tap & die set, your best bet is to get a nut & bolt of each size/pitch so as to be able to "test" the thread(s) in question.
-pt
Posted by: kconway Jul 9 2007, 11:41 PM
The reason I was asking is I was going to purchase the most common lengths from Mcmaster Carr, but noticed the M8 comes in two different thread pitches.
Kev