Do you guys know if anyone makes an aftermarket front trunk pan? Has someone replaced one. Thanks Mike
Is this for an A/C cut out?
Try these guys
http://www.restoration-design.com/index.html
$175
No AC just rust, RD only makes the rear trunk pan, seems odd because I know several guys have rust problems or as you stated AC hole. I suppose I'll have to find someone who is cutting one up; I don't have the skill, tools and talent a lot of guys have on this site to make a good and presentable repair. Mike
just get one out of a parts car...in good shape...
just get one out of a parts car...in good shape...
I could've sworn they had a front piece at some point too.
Try giving them a call.
Their website shows a front pan-Part 16 175.00
Try sending member "fitsbain" a PM. He may have a good used one. Do not email him, for some reason the link never gets it there I have one aswell, but I may be using it.
I did exactly what you are asking. Here is my experience with pictures.
1) My original front trunk. Cut for A/C. Crumpled. Rusted out at the suspension points. CRAP!
2)The replacement part, cut from another car. Post up a wanted add, or bug someone with a parts car and you will find one right quick.
3)Drilling out all the old spot welds, and making my initial cut to remove the bulk of the original front trunk. In this pic, there is more cutting to the fuel tank wall left to do yet.
4)I still have to drill out the spot welds on the front, but the old metal is almost all out.
5)Lots of welding later.... All I need to do is add seam sealer. FIN!
This project represented my first go with sheet metal welding. From start to finish, it was probably 40 hours of work, with me learning what the hell I was doing as I did it.
Zach
I also got a front trunk floor from a donor car and welded it in place...
Here's a http://www.tampabay914.com/7491420050327.html to my website showing the steps I followed. I hope this helps....
-- Rob
Thanks everyone, I will use your suggestons and ptotos to guide me on the pan replacement; I will also persue getting another pan from a donor. Thanks a lot. Mike
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)