I read an articale on engine bay temps. and where the hottest places are within the confines of the compartment. Higher temps where seen twards the back.
would it be possible to vent the vertical tin on the back of the motor to release the hot air?
Maybe a couple of holes with thermo fans? They could even be active only at idle to draw air out of the engine bay?
Just a thought!
Maybe I should put sown the crack pipe and step away from the keyboard
There's a grill above the engine already and heat billows out of it everytime the car is stopped
My engine driven fan @7000 RPM pumps enough air through the GT lid that I doubt hot air on top of the tin has a chance inhell of making a difference
I was thinking about this too, but to use it to get fresh air from the engine compartment air over an aux. oil cooler.
Something like this
Sorry I can't draw but you get the idea.
A lot of guys already mount their coolers by the Trans and I figure a little guide tins from the engine compartment would be all you need to get some "fresher" air through it as opposed to the warm air from under the car.
If you add a fan drawing air from the engine compartment you will be competing with the engine fan for the available air, and further lower the air pressure in the engine bay. Will this be significant or not?
I recall someone placing an oil cooler with fan in the right fender well with a cutout in the wall where the battery used to be located drawing air from the engine bay and dumping it into the fender well. I never heard if this arrangement worked well or not.
Your efforts and money would be better spent on a front oil cooler installation.
"hee hee I am becoming a post whore!"
I think if something worked really good you would hear about it here. But since I don't remember it either I bet it didn't work good at all.
I pu my oil cooler in the passnger side rocker panel.
Louvered the panel and it works OK. I suspect it is because I was using a sandwhich plate at the filter.
Now going full flow and I think it will work better.
Back on topic, leave the design of the engine tin alone.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)