Not sure if this has been done.. has any one developed and or converted their
side shifter bushing ( where shift rod connects to cup /ball) to brass?
part number 914-424-224-02-M100 on bird board.
Mine has excessive clearance ie1-2 mm - thus when shifting in to 1st some times i will engage 3rd.
Any suggestions is much appreciated
Yup, been done by a few. Searching will yield pics, too.
Patrick Motorsports sells a brass one thats oversize on the OD, since the hole is wallowed out so often.
http://www.patrickmotorsports.com/cgi-bin/main
If you put it in backwards, you can't get it into some of the gears anymore. Don't ask me how I know.
Dont you mean self-lubricating Bronze?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)