installed my rear sway, and the thing must have been on a car that did nothing but right hand turns as it appears to be bent higher on one side than the other.
can ya shim the mounts to correct this?
I'm also thinking of an adjustable link, but its pretty far off as it is.
maybe both... anyone done this one?
BTW- Weltmeister sway bushings are sooooo squeeky, yuk.
Did it bend AFTER you installed it..???????
If so..... You have a bind that NEEDS to be taken care of before you do anything else.
I might be down your way tomorrow on Biz.... Ya wanna hook up and see what we can do..???
Cheers,
Clayton
hell yes.
i'll pm you.
fixed!
took out the weltmeister and reinstalled the soft, slightly worn stock bushings and it moves freely again, no squeeking, and both ends of the bar are level.
It seems that my mounts are ever so slightly out of alignment, not a problem with soft stock bushings, but the hard weltmeisters with no give created a bind and tweek on my bar.
They tweeked on my bar.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)