Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Used mallory unilite
Posted by: Vacca Rabite Oct 16 2007, 06:47 PM
So, as I am setting up my engine for the shakedown fireing this weekend, I put the Mallory on. It has all the plug wire attached to it. How do I figure out what plug wire goes to what spark plug.
Right now the engine is at TDC, and the mallory has been installed as in the manual I downloaded.
Zach
Posted by: t collins Oct 16 2007, 07:54 PM
So, as I am setting up my engine for the shakedown fireing this weekend, I put the Mallory on. It has all the plug wire attached to it. How do I figure out what plug wire goes to what spark plug.
Right now the engine is at TDC, and the mallory has been installed as in the manual I downloaded.
Zach
Hey Zach,
Remove the dist. cap and note the position of the rotary button it should now be pointing to no. 1, place the no.1 wire in that hole. Now in a clock wise direction on the cap place the no. 4 wire on the cap, then the no. 3 and last no. 2
Posted by: jaybird840 Oct 16 2007, 08:34 PM
Man, do yourself a favor and read the Mallory install threads I posted last week... And for Heaven's sake, make sure it's wired up right. Cost me a $100 bill for having it wired backwards!!!!
--Jaybird
Posted by: Aaron Cox Oct 17 2007, 11:13 AM
if the engine is at TDC for #1, rotate the dizzy to point at ANY plug on the cap.
You have no arbitrarily selected that node on the cap to be cylinder #1.
continue plug wire hook up in the 1 4 3 2 order.
(it makes no difference how a mallory is installed, as it is optical pickup vs points)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)