I tried searching and seems all the posts I found were about hooking it up...
so I assume it can fit in there.
but as I was looking and about to plop it in, it looks like the tin is in the way
since it is a larger diameter than the current 009. the 009 is right up against it.
so what does everyone else do here? do I just take a BFH and make room?
No expert here, but from reading past post on this subject, I believe most people running the mallory modifiy the tin to make it fit.
Beat the tin in a little bit with a hammer where it interferes with the dizzy body. It's pretty self-explanatory once you get started.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)