This might be tricky to measure unless you have one on the bench but a measurement from the firewall to the bellcrank would be a big help as I can work out the total length from that.
There's a control cable manufacturer near my office who can make me a new one.
The measurement I'm guessing is 2300mm
I have a used one, but it's at GPR so that he can do the same as you, measure it to have repros made. If nobody can get you the measurements for you I'll go get mine and measure it.
much appreciated, thanks
Bumpety bump. Can anyone help?
I took a look at mine and based on your request for the measurement from the firewall to the bell crank I am not sure what that will tell you? I measured the total length at 46" but the sheathing stops short of the bell crank and is attached to a bracket before the bell crank.
Sorry I didn't flake out as much as it looks like I did. GPR sent mine to get it duplicated at Terry Cable but they never sent it back. Dave says he'll get me a new one eventually.
Thanks guys, so Jeff the total length of the metal cabling is 46" (eye to eye)?
I will make up some outer sheathing but it's the inner actual cable that I need to get swaged.
If it's easier I can work out the total length if I have the measurement from the firewall backwards (unless someone has one on the bench)
I'll look later this morning and see if I can find my cable. I pulled it some 3 years ago or so and I'm not even entirely certain where it's at.
The one I have is 8' 5" from ball end to ball end. The sheath is 40 3/4 " Hope that helps Al
Brilliant! thanks guys -massive help
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)